www.spendwithpennies.com Introduction: DIY Bird Feeder Bringing Nature to Your Backyard Want to add some life and beauty to your yard? Building your own bird feeder is a fun and rewarding project that can attract a variety of feathered friends. Not only does it provide a food source for birds, especially during lean months, but it also offers a wonderful opportunity to observe them up close. This guide will walk you through a simple DIY bird feeder project using readily available materials.
Materials You'll Need:
- A plastic bottle (soda or water bottle works great)
- Scissors or a craft knife (adult supervision required for children)
- Two wooden spoons or dowels
- String or wire for hanging
- Birdseed
Step-by-Step Instructions: Step 1: Preparing the Bottle Carefully wash and thoroughly dry your plastic bottle. Remove any labels. This is important to prevent contamination of the birdseed.
Step 2: Creating the Spoon/Dowel Holes Decide where you want to insert the first wooden spoon or dowel. Use scissors or a craft knife (exercise caution!) to create two small holes, one on each side of the bottle, directly across from each other. The holes should be just large enough to snugly fit the handle of the spoon or dowel. Make sure the holes are aligned so the spoon/dowel will sit level.
Step 3: Inserting the First Spoon/Dowel Push the handle of the spoon or dowel through the holes, creating a perch for the birds. Leave a generous portion of the spoon bowl or dowel exposed outside of the bottle for the birds to stand on.
Step 4: Creating the Feeding Holes Below the spoon/dowel, create a series of smaller holes on each side of the bottle. These holes will allow the birdseed to dispense onto the spoon. Start with small holes; you can enlarge them later if needed. Ideally, these holes should be just large enough for the birdseed to trickle out easily, but not so large that the seed pours out.
Step 5: Inserting the Second Spoon/Dowel (Optional, but Recommended) Repeat steps 2-4 further up the bottle to add a second spoon/dowel and feeding area. This will provide more feeding space for multiple birds. Position this second set of holes a decent distance above the first set.
Step 6: Creating a Hanger Near the top of the bottle, cut two small holes on opposite sides. Thread a piece of string or wire through these holes to create a loop for hanging the bird feeder. Make sure the loop is securely fastened so the feeder doesn't fall.
Step 7: Filling the Feeder Fill the bottle with birdseed. A funnel can be helpful for this step. Make sure the seed is dispensing onto the spoons/dowels. If it's not, slightly enlarge the dispensing holes.
Step 8: Hanging the Feeder Choose a suitable location to hang your bird feeder. A tree branch or shepherd's hook are good options. Make sure the location is relatively sheltered from wind and rain and is easily visible from your windows so you can enjoy watching the birds.
Conclusion: Enjoy Your New Bird Feeder! Congratulations! You've successfully created your own bird feeder. Now, sit back and enjoy watching the birds flock to your creation. Remember to regularly refill the feeder and clean it periodically to prevent the spread of disease. Happy birdwatching!
Easy Chicken Recipes In Under 30 Minutes
www.licious.in Rotisserie Chicken
www.spendwithpennies.com Raising Chickens 101: A Beginner's Guide To Chickens
www.almanac.com
0 komentar:
Posting Komentar